Boat Center Hammond, IN

Service Rates

2019 Cabela's Service Rates

STANDARD SERVICE RATES

INSTALLATIONS*

BASIC BOW GPS/FISHFINDER $110.00
BASIC CONSOLE GPS/FISHFINDER $220.00
STRUCTURESCAN®** $220.00
TROLLING MOTOR (TM) ESTIMATE
TM-PRE-WIRED OR REPLACEMENT $220.00
STEREO & SPEAKERS INSTALLATION ESTIMATE
BIMINI TOP INSTALL STARTING AT $220.00
SHALLOW WATER ANCHOR STARTING AT $220.00
ELECTRIC ANCHORMATE® ESTIMATE
AERATOR PUMP REPLACEMENT STARTING AT $110.00
BILGE PUMP REPLACEMENT STARTING AT $110.00
NEW KEEL PROTECTOR INSTALL $220.00
GUIDE-ON TRAILER BUNKS (2) $110.00
BATTERY CHARGER STARTING AT $110.00
12V ACCESSORY PLUG $110.00
FUEL/WATER SEPARATOR $110.00
ATV/UTV ACCESSORIES INSTALL ESTIMATE

SERVICES*

ANNUAL SERVICE – 2.5-30HP OUTBOARD $165.00
ANNUAL SERVICE – 40-115HP OUTBOARD $220.00
ANNUAL SERVICE – 150-300HP OUTBOARD $275.00
ANNUAL SERVICE – 350HP OUTBOARD $330.00
ANNUAL SERVICE – STERNDRIVE $275.00
OUTBOARD IMPELLER STARTING AT $165.00
STERNDRIVE IMPELLER STARTING AT $220.00
REPACK TRAILER BEARINGS PER AXLE W/BRAKES $220.00
REPACK TRAILER BEARINGS PER AXLE $165.00
TRAILER LIGHT REPLACEMENT STARTING AT $27.50
DIAGNOSTIC SERVICE STARTING AT $110.00
PROP RECONDITIONING ESTIMATE
34-POINT INSPECTION*** $55.00
ATV/UTV OIL CHANGE $55.00
FULL ATV/UTV SERVICE STARTING AT $165.00
ATV/UTV CV JOINT BOOT R&R $165.00
SHOP RATE $110/HR
* Does not include parts & shop supplies
** Additional cost for networking
*** Free w/paid service
CERTIFIED REPAIR SERVICES AVAILABLE
OUTBOARD MOTORS
  • Replace spark plugs
  • Replace impeller
  • Lubricate all points
  • Adjust carburetor
  • Check engine timing
  • Drain & replace gear lube
  • Lubricate prop shaft
  • Check trim fluid
  • Check control cables
  • Remove engine deposits
  • Check Ignition system
  • Replace H2O separator
  • Inspect fuel filter element (EFI models)
  • Replace fuel filter (EFI models)
  • Grease bearings
  • Inspect Belt
STERNDRIVE MOTORS
  • Replace spark plugs
  • Change engine oil & filter
  • Replace impeller
  • Drive belt inspection
  • Replenish all fluids
  • Lubricate propeller
  • Replace sterndrive
  • Gear lube
  • Inspect ignition
  • Grease bearings
  • Retourque gimbal ring
  • Lubricate gimbal bearings
  • Check cables & linkage
  • Inspect drive unit bellows
  • Adjust carburetor, if necessary
  • Adjust timing, if necessary

DOWNLOAD OUR SERVICE RATES